Golf GL L4-2.0L (AVH) (2002)
Tip:
Battery voltage must be substantiated by a Midtronics M0R340V printout. Printout must be attached to the repair order. If ECM is requested by the
Warranty Test Center, a copy of the Midtronics Tester printout must be sent with the ECM along with all other supporting documentation.
-
With battery fully charged:
-
Connect the VAS 5051/5052 Diagnostic tool.
-
Switch ignition ON.
-
Select "Vehicle Self Diagnosis".
-
Interrogate and erase DTC memory.
-
Perform throttle adaptation (see appropriate Repair Manual and Repair Group 23 or 24).
-
Start engine and allow to run briefly, then switch engine OFF.
-
Repeat above step (Start/Shut OFF) 5 times.
-
Check DTC memory again.
If MIL does not illuminate and DTC has not returned:
^
A low battery condition most likely caused the DTC to be stored.
-
Set readiness code.
If MIL illuminates or DTC has been stored again, perform the following:
-
Replace ECM (see appropriate Repair Manual and Repair Group 23 or 24).
-
Set readiness code.
When procedure applies to vehicles within the New Vehicle Limited Warranty, use the table.