Golf GL L4-2.0L (AVH) (2002)
Continued for all vehicles
-
Then subsequently check the DTC memory of the new engine control module and erase the DTC memory if necessary.
-
Perform idling check and carry out test drive.
During road test the following operating conditions must be fulfilled:
-
The coolant temperature must exceed 80 °C.
-
When the temperature is reached, the operating conditions
Idling
Part throttle
Enrichment
Full throttle
Overrun
must be attained several times.
-
Again check the control module DTC memory
-
Generate readiness code.
Engine Control Module, Adapting to Electronic Immobilizer
Engine Control Module, Adapting to Electronic Immobilizer
Special tools and equipment
-
V.A.G 1551 scan tool or 1552 scan tool with cable VAG 1551/3
Conditions
-
Authorized vehicle key required.
Work sequence
-
Connect VAG 1551 scan tool or or 1552 scan tool with cable VAG 1551/3.
-
Switch on ignition.
-
Operate scan tool or vehicle system tester taking into account the information on the display:
-
Press key 1 for "Rapid data transfer".
-
Press keys 1 and 7 for address word "instrument cluster" and confirm entry with Q key.
Indicated on display:
1J0919991A A4-COMBIINSTR. VDO X00
Coding 20142
WSC XXXXX
-
Press the -> key.
Indicated on display:
IMMO IDENTO.: VWZ7Z0555153
->
-
Press the -> key.
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press keys 1 and 0 for function "Adaption" and confirm entry with Q key.
Indicated on display:
Adaption
Feed in channel number XX
-
Press key 0 twice for "Channel number 0" and confirm entry with Q key.
Indicated on display:
Adaption
Q
Erase learned values?