Golf GL L4-2.0L (AVH) (2002)
Alignment: Service and Repair
Rear Wheel
Camber, Adjusting
Rear wheel camber, adjusting
Camber cannot be adjusted.
If vehicle checks outside of specification, check trim height and adjust if necessary.
If specification cannot be obtained, check axle beam for damage and replace if necessary.
Toe, Adjusting
Rear wheel toe, adjusting
If vehicle is out of specification, check trim height and balance if necessary
Rear axle total toe is not adjustable
Only by sliding brackets is it possible to balance individual toe values.
If, after attempting above method, vehicle remains out of specification, check axle beam for damage and replace if necessary
-
Loosen all bolts at bracket -1-
-
Slide bracket -1- laterally.
2. Rear axle beam
-
Tighten bolts 75 Nm (55 ft. lbs.).
NOTE: Always use new bolts