Golf GL L4-2.0L (AVH) (2002)
-
Pull off wheel bearing/wheel hub unit from stub axle.
-
A - Puller with leg clamp, e.g. Kukko 20/2
-
Pull off bearing inner race from stub axle.
-
Only use puller - A - with leg clamp e.g. Kukko 204-2 (commercial type).
Installing
-
Install wheel bearing/wheel hub unit as far as possible on stub axle.
-
Attach special tool 3420 and pull wheel bearing/wheel hub unit on to stop.
Caution: Make sure that the hubs/wheel bearing unit does not tilt!
-
Remove assembly tool 3420 ab.
-
Use a new 12-point nut - A - and tighten to 175 Nm (129 ft. lbs.).
-
Install brake disc.