Golf GL L4-2.0L (AVH) (2002)
Note:
^
When installing new gears or a new output shaft consult technical data
^
If the output shaft or tapered roller bearings have been replaced then perform output shaft adjustment
1 - Clutch housing
2 - Oil deflector ring
3 - Dished washer
^
Pulling out, Refer to Fig. 1
^
Pressing in, Refer to Fig. 2
4 - Outer race/tapered roller bearing
^
Pulling out, Refer to Fig. 3
^
Pressing in, Refer to Fig. 4
5 - Tapered roller bearing inner race
^
Pressing off, Refer to Fig 8
^
Pressing on, Refer to Fig 9
6 - Output shaft
^
For 1st-4th gear
7 - Needle roller bearing
^
For 2nd gear
8 - 2nd gear
9 - Synchro-ring
^
(Inner ring for 2nd gear)
^
Checking for wear, Refer to Fig. 10
^
Check lugs for scoring
^
Installation position, Refer to Fig. 12
10 - 2nd gear outer ring
^
Insert in the synchro-ring (item - 9 -)
^
Replace if scored
^
Installation position, Refer to Fig. 12
11 - 2nd gear synchro-ring
^
Checking for wear, Refer to Fig. 11
^
Installation position, Refer to Fig. 12