Golf GL L4-2.0L (AZG) (2001)
^
Apply a 10 mm diameter spot of 3M(R) Channel Bonding and Sidelite Adhesive, Part No: 08641, to one side of the rubber on each isolator.
Tip:
Adhesive application tool is available locally.
New Beetle Shown:
^
Install rubber isolators into regulator clamps.
New Beetle Shown:
^
Install glass into window regulator clamps, see Repair Manual Group 64, Glass, Window regulators, Door window adjusting.
-
Apply loctite 242(R) (obtain from local supplier) to exposed window regulator clamp bolt threads.
-
Tighten each window regulator clamp bolt to 11 Nm (97 in. lbs.).
^
Reset pinch protection as necessary.
^
Close and clean window.
Tip:
DO NOT operate window for 30 minutes. This will allow adhesive to cure.