Golf GL L4-2.0L (AZG) (2001)
-
Press the -> key.
-
Press keys 0 and 6 for the "End output" function and confirm input with the Q key.
-
Switch off ignition.
If the specification is not obtained:
-
Remove shelf on driver's side:
-
Pull the connector off the clutch pedal switch.
-
Connect multimeter to measure resistance between contacts 1 and 2.
Specification: approx. 0 Ohms
-
Depress the clutch pedal.
Specification: Infinity Ohms (no continuity)
If the specification is not attained:
-
Replace clutch pedal switch.
NOTE: Observe installation position of clutch pedal switch in bearing bracket upper assembly hole.
-
Check DTC memory, if necessary, repair any faults and then erase DTC memory, checking and erasing DTC memory.
See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Clearing Diagnostic Trouble Codes
If the specification is obtained:
-
Connect multimeter using aux. cables from VAG 1594 to measure voltage between contact 1 and Ground. Then switch ignition on.
Specification: At least 11.5 V