Golf GLS L4-2.0L (AEG) (2001)
-
Guide cutting thread in between lip and window flange with help of tube -1- (If cutting thread should break, then cutting wire can also be used). If
gap is too small guide cutting thread on outside and press under lip with a plastic wedge.
-
Place cutting thread around side window.
-
Secure outer end of thread to pull toggle from VAG 1351 to counter-hold.
-
Secure inner end of thread to winding device VAG 1654 and cut out window by moving winding device as necessary.
NOTE: Press cutting thread against window glass with plastic wedge during cutting process, in order to have clearance at window flange.
Broken Side Window, Removing
The removal of a broken side window is very similar to the removal
of a broken rear window See: Rear Window Removal and Installation/Broken Rear Window, Removing
Side Window, Installing
NOTE: Information on the material used to pre-coat the side windows (2-door) can be found at Broken Rear Window, Removing. See: Rear Window
Removal and Installation/Broken Rear Window, Removing
Preparing old undamaged window for glazing See: Related Information For All Flush Bonded Windows/Preparing Removed Undamaged Window For
Installation
Preparing new window for glazing See: Related Information For All Flush Bonded Windows/Preparing New Window For Glazing
Preparing body flange for glazing See: Related Information For All Flush Bonded Windows/Preparing Body Flange For Glass Installation
Installation instructions See: Related Information For All Flush Bonded Windows/Installation Instructions
Curing time See: Related Information For All Flush Bonded Windows/Curing Time