Golf GLS L4-2.0L (AEG) (2001)
Housing Assembly HVAC: Service and Repair
Assembly Vehicles Without Air Conditioning
NOTE: This applies to vehicles without Air Conditioning or Digimatic Climate Control. For these vehicles, please see Heating and A/C Unit. See:
1
-
Heater core
-
Always replace coolant after removal/replacement
-
Remove instrument panel. See: Body and Frame/Interior Moulding / Trim/Instrument Panel/Dash Board/Service and Repair
-
Loosen instrument panel cross member. See: Body and Frame/Interior Moulding / Trim/Instrument Panel/Dash Board/Service and Repair
-
Carefully pinch off both coolant hoses to heater core and disconnect hoses.
-
Seal off heater core to prevent coolant from running out
CAUTION: The cooling system is pressurized when the engine is warm. Wear gloves and other protection and carefully release
system pressure if necessary, before performing repairs.
-
Partially remove heating and ventilation unit.
-
Press retainer clips and remove heater core.
2
-
Self tapping screw
-
Use if retainer clips break
3
-
Air distribution housing
4
-
Servo motor for fresh/recirculating air door -V154-
5
-
Self tapping screw
6
-
Fresh air blower -V2-
7
-
Cover
8
-
Self tapping screw
9
-
Series resistor -N24-
10
-
Sheet metal screw
11
-
Central flap lever
12
-
Temperature flap lever
13
-
Base plate
14
-
Heater core/bulkhead seal
Heater core/bulkhead seal, installation position