Golf GLS L4-2.0L (AEG) (2001)
-
Measure resistance between terminals 2 + 3 of switch.
Specified value:
-
Clutch pedal not depressed: max. 1.5 Ohms
-
Clutch pedal depressed: Infinite Ohms
Continuation for all vehicles
If specified values are not obtained:
-
Replace Clutch Vacuum Vent Valve Switch -F36-.
NOTE: Note installation position of clutch vacuum vent valve switch in the upper installation bore of mounting bracket.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified values are obtained:
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring Test
Vehicles with 2-pin clutch vacuum vent valve switch
-
Check wire between test box and 2-pin connector for open circuit according to wiring diagram:
-
Vehicles with engine code AEG
Terminal 1 + socket 48
Wire resistance: max: 1.5 Ohms
-
Vehicles with engine code AVH, AZG
Terminal 2 + socket 39
Wire resistance: max: 1.5 Ohms
Vehicles with 4-pin clutch vacuum vent valve switch