Golf GLS L4-2.0L (AEG) (2001)
-
Set multimeter to "Voltage measurement" range.
-
Connect multimeter using aux. cables from VW1594 to measure voltage at terminals -1- and -2- (harness connector to Engine Control Module
(ECM).
-
Start engine and run at idle.
-
Measure voltage supply and observe display group 41, display field 2.
Display: Htg.bC.ON
-
Specified value: 11.0-14.5 V
Display: Htg.bC.ON/Htg.bC.OFF (alternating)
-
Specified value: Between 0.0-12.0 V fluctuating
-
Turn off ignition.
If no voltage is present:
-
Remove wiper arms and plenum chamber cover.
-
Connect VAG1598/22 test box to control module wiring harness.
-
Check wiring between test box and 4-pin harness connector for open circuit according to wiring diagram.
Terminal -2- + socket 27
Wire resistance: max. 1.5 ohms
If the specified value is obtained: