Golf GLS L4-2.0L (AEG) (2001)
-
Bond to gear lever housing
12. Transmission-selector lever
13. Damper
14. Selector housing
15. Bushing
16. Bolt, 25 Nm
17. Fulcrum pin
18. Guide bushing
19. Spring
-
Installing = Fig. 2
20. Gate selector bracket
21. Torx screw, 5 Nm
22. Base plate
-
Open tabs to remove
-
Replace
23. Lock washer
24. Gate selector cable
-
On gate selector bracket
-
Installation position
25. Gear selector cable
-
Press onto gear shift guide
-
Installation position
26. Hex nut, 25 Nm
27. Bushing
-
Only fits in one position
28. Lock washer
Fig. 1 Removing and installing circlip
-
To remove and install circlip pull gear lever in direction of arrow -A- while pushing down spacer bushing onto stop with a screwdriver in arrow
direction -B-.
Note: Do not tilt spacer bushing when pushing down. Carefully release pressure at groove in gear lever for circlip.
Fig. 2 Installing spring