Golf GLS L4-2.0L (AVH) (2002)
-
Insert selector lever cable -3- in mounting bracket and press onto selector lever -2-.
-
Fit new selector lever cable locking plate -1- on mounting bracket.
Installation position:
Angled end of locking plate must point toward end of selector lever cable.
-
Insert complete selector mechanism with selector lever cable in tunnel underside.
-
Screw in bolts -arrows B- by hand.
-
Tighten front of selector mechanism (2 nuts) to 25 Nm.
-
Shift selector lever from "P" to "2".
-
Selector lever mechanism and selector lever cable must move freely. If necessary replace selector lever cable or service selector lever
mechanism.
-
Shift selector lever into "P" position.
-
Tighten nuts -arrows A- to 10 Nm.
-
Tighten both bolts -arrows B- to 25 Nm.
Note: When doing this, ensure seal remains seated correctly.
-
Insert protective sleeve of selector lever cable in cover.
-
Install tunnel heat shields front and center.
-
Fit selector lever cable in bracket on front heat shield.
-
Reconnect exhaust system.