Golf GLS L4-2.0L (AZG) (2001)
Seat Latch Cable: Service and Repair
Cable For Locking Backrest (Front Seat) (2-Door)
Assembly overview
1
-
Cover
2
-
Clip
3
-
Grip
4
-
Backrest frame
5
-
Locking lever
6
-
Cable upper hook
7
-
Cable
8
-
Cable center guide
9
-
Cable lower hook
10
-
Cable lower guide
11
-
Transfer rod
12
-
Locking sleeve
Removing
-
Remove front seat.
-
Remove front seat backrest.
-
Pry off grip -3- and unclip cover -1-.
NOTE:
-
On 2-door vehicles the backrest is secured to the seat base with 2 bolts (24 Nm or 18 ft lb).
-
Always replace clips -2- and locking sleeve -12-.
-
Remove cover and padding.
-
Break-off the four small tabs of the locking sleeve -12- and drive the remainder of the locking tab -12- into transfer rod using punch -11-.
-
Press locking lever -5- down and pull out cable hook -6-.
-
Unclip cable center guide -8- from backrest frame -4-.
-
Pull transfer rod -11- out from backrest frame sufficiently to allow lower cable guide -10- to be unhooked.
-
Unhook cable hook -9- and pull cable -7- out from backrest frame.
Installing