Golf GLS L4-2.0L (AZG) (2001)
<-- Place electrical connector -1- into ABS control module and push in direction of -arrow 2-
<-- Lock electrical connector to ABS control module by pushing latch down -arrow 3-
^
If applicable, reinstall secondary air relay box and reinsert harness in support clip
^
If applicable, reconnect electrical connector to brake fluid reservoir
<-- Reinstall air filter box and secure with 2 screws -6- and tighten to 6 Nm (53 in. lbs.)
<-- If applicable reconnect air hose -4- from secondary air pump to air filter box -5-
<-- Reconnect vacuum line -7- to air box (TDI vehicles only)
<-- Reconnect air intake hose to mass air flow sensor and secure with clamp -3-
<-- Reconnect electrical connector -1- to mass air flow sensor -2-
^
Reconnect the ground cable (GDN) from the negative (-) battery terminal
^
In the vehicle, remove brake pedal depressor from the brake pedal
^
Proceed to Section D
Section D
Section D - Code ABS Control Module
^
Connect VAS 5051 to data link connector located under dash left of steering column