Golf GLS L4-2.0L (AZG) (2001)
Exhaust Manifold: Service and Repair
Exhaust Manifold, Removing and Installing
Special tools
^
V.A.G 1331 Torque wrench 5 to 50 Nm (3.7 to 37 ft. lbs.), or equivalent
Removing
-
Remove engine cover.
-
Remove intake hose:
-
Remove pressure and vacuum hoses from combi-valve.
-
Remove connector pipe from combi-valve and exhaust manifold.
-
Remove warm air collector plate.
-
Remove right hand inner CV joint protective cover.
-
Disconnect right drive shaft from transmission:
-
Remove protective cover (arrows) and disconnect 4-pin connector (black) -1- for oxygen sensor 1 -G39-.
-
Remove oxygen sensor 1 -G39- wiring retainers.
-
Remove front exhaust pipe with catalyst and bracket.
-
Remove exhaust manifold by removing lower nuts from below and upper nuts from above.
Installing
Installation is the reverse of removal. Note the following:
^
Always replace all seals and self-locking nuts
^
Tightening torques.
^
Drive shaft to transmission: 40 Nm (30 ft. lbs.)
-
Check Diagnostic Trouble Code (DTC) memory:
-
Display Readiness code:
-
Readiness code must be reset if ECM is subject to low voltage with ignition ON or if DTC memory is erased.