Golf GLS L4-2.0L (AZG) (2001)
-
Loosening and tightening.
2
-
Clutch plate
3
-
Shims
-
To adjust gap between clutch plate and pulley
-
Gap: 0.4.. .0.8 mm (0.0150...0.023 in)
4
-
Circlip
-
Always replace
-
Flat side faces compressor
-
Must be seated correctly in groove
5
-
Clutch pulley
6
-
Circlip
-
Always replace
-
Flat side must face compressor
-
Must be seated correctly in groove
7
-
Clutch coil
NOTE: A thermo-fuse integrated into the clutch coil protects the A/C clutch in the event of overheating (e.g.: due to a binding compressor) The clutch
coil circuit is interrupted.
8
-
Retainer
-
With screw
9
-
Retainer
10
-
Retainer
11
-
Bolt
12
-
Compressor
-
Manufacturer: Sanden
13
-
Threaded bushing
A/C Clutch -N25- (Sanden), Removing And Installing
A/C Clutch -N25- (Sanden), Removing And Installing
Special tools, testers, measuring instruments and auxiliary items required
-
Special tool 3212 (or equivalent)
-
Two arm puller
-
Three arm puller
-
Depth gauge
-
Torque wrench (5 - 50 Nm)
NOTE:
-
It is not necessary to discharge the refrigerant circuit to remove and install the A/C clutch.
-
Remove ribbed belt See Repair Manual, Engine Mechanical, Repair Group 13.
-
On Diesel engines, remove charge air cooler 1.9 Liter TDI 4-Cyl. Diesel Engine Mechanical.
Hex Nut, Removing and Installing
A/C Clutch -N25- (Sanden), Removing And Installing