Golf GLS L4-2.0L (AZG) (2001)
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Checking voltage supply
Vehicles with engine code AEG
Connect diode test lamp to connector of fuel injector to be tested terminal 1 and Ground (GND).
Vehicles with engine code AVH, AZG
Connect diode test lamp to connector of fuel injector to be tested terminal 1 and Ground (GND).
Continuation for all vehicles
-
Operate starter and test voltage supply for fuel injector. LED must light up.
-
Switch ignition off.
If LED does not light up:
-
Check wire between 2-pin connector terminal 1 and the Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram. Wire resistance:
max: 1.5 Ohms
Activation and voltage supply, checking
Vehicles with engine code AEG