Golf GLS L4-2.0L (AZG) (2001)
If the specification is not obtained:
Checking resistances and wiring
-
Separate 2-pin connector to Knock sensor (KS) 1 -G61- -1- and/or 2- pin connector to Knock sensor (KS) 2 -G66- -2-.
-
Measure resistance between the contacts 1+2 at connections to knock sensors.
Specification: Infinity Ohms
If the specification is not obtained:
-
Replace knock sensor(s)
-
Check DTC memory, if necessary, repair any faults and then erase DTC memory.
See: Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
See: Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Clearing Diagnostic Trouble Codes
If the specification is obtained:
-
Remove wiper arms and cowl panel.