Golf GLS L4-2.0L (AZG) (2001)
NOTE:
-
Message "Function is unknown or cannot be carried out" is displayed if an unauthorized code number has been entered
-
ECM identification and coding are displayed in upper right corner of screen
-
Press (<) button when "Coding of vehicle completed" comes on screen in upper left corner
-
Proceed to Section E
Section E
SECTION E - Create Engine Readiness Code
Requirements for generating engine readiness code:
-
Vehicle in stationary position
-
Automatic transmission selector lever in P (Park) or N (Neutral) position
-
Turn off all electrical consumers (e.g. lights and rear window defroster)
-
Throttle valve angle less than 10 percentage display group 3, display field 3
-
Coolant temperature at least 85°C ->display group 4, display field 3
-
Intake air temperature less than 60°C -> display group 4, display field 4
-
Select "04 - Basic Settings"
-
Press buttons -9- & -8- for Display Group 98: Throttle Body Adaptation
-
Press "Q" button to confirm
-
Press (<) button when "ADP. O.K." is on screen
-
Start engine and let idle
-
Press buttons -7- & -7- for Display Group 77: Secondary Air Check
-
Press "Q" button to confirm
NOTE: Test may not start until temperature (on screen) reaches approx. 76.5°C
-
Press (<) button when "Syst. OK" is on screen
-
Press buttons -7- & -0- for Display Group 70: EVAP System
-
Press "Q" button to confirm
NOTE: Test may not start until temperature (on screen) reaches approx. 76.5°C
-
Press (<) button when "TBV OK" is on screen
-
Press buttons -7- & -1- for Display Group 71: Leak Test EVAP System
-
Press "Q" button to confirm
-
Press (<) button when Syst. OK is on screen
-
Press buttons -3- & -4- for Display Group 34: Oxygen Sensor Aging
-
Press "Q" button to confirm
-
Using VAG 1788/10 set engine speed to 2200 - 2800 RPM
NOTE: Test may not start until temperature (on screen) is higher than 352.0°C
-
Press (<) button when B1-P1. OK is on screen
-
Press buttons -4- & -6- for Display Group 46: Catalytic Converter
-
Press "Q" button to confirm
-
Using VAG 1788/10 set engine speed to 2800 - 3200 RPM
NOTE: Test may not start until temperature (on screen) is higher than 352.0°C
-
Press (<) button when Cat "B1 OK" is on screen