Golf GLS L4-2.0L (AZG) (2001)
-
After program has run completely, this message appears at the bottom of the screen, in a green box.
NOTE: VAS 5051 will automatically reboot to the Start-up screen.
-
If ECM does not need reprogramming, this message will appear at the bottom of the screen, in a blue box. No further work is required.
NOTE: VAS 5051 will automatically reboot to the Start-up screen.
-
If this message appears in a red box at the bottom of the screen, reprogramming is not necessary.
NOTE: VAS 5051 will automatically reboot to the Start-up screen.
-
Turn ignition switch to "OFF" position and disconnect VAS 6103 cable from vehicle
-
Proceed to SECTION D
Section D
Section D - Code Control Module
IMPORTANT: Although a code is shown in the upper right hand corner of screen, the control unit still must be coded.
-
Connect VAS 5051 / 6 diagnostic cable harness to data link connector located under dash on left side
-
Turn Ignition "ON"
-
From VAS 5051 Start-Up screen press "Vehicle Self Diagnosis" button
-
Select "01 - Engine Electronics"
-
Select "02 - Interrogate fault memory"
-
Press (<) button
-
Select "05 - Erase fault memory" if required
-
Press (<) button
-
Select "11 - Login-Procedure"
-
Press buttons -1-, -2-, -8- and -3- to input Login code 1283
-
Press -Q- button to confirm
-
Press (<) button when "Function Performed Successfully" comes on in upper left corner of screen
-
Select "07 - Code Control Unit"
IMPORTANT: Although a code is shown in the upper right hand corner of screen, the control unit still must be coded.
-
Enter relevant code number for vehicle noting model year and options
-
Press -Q- button to confirm input