Golf GTI L4-1781cc 1.8L SOHC (HT) (1985)
Fig. 19 One-way clutch support, checking bail valve
-
check sealing of ball valve by inserting piece of hose into hole (arrow) and sucking
Fig. 20 Final drive housing oil seal, Installing
-
before installing adjust end play and insert shim
-
sealing lip faces toward final drive
Fig. 21 Drive flange circlips, determining thickness
Note
When replacing circlip, drive flange shaft, differential housing or pinion/side gears, thickness of circlips (arrow) must be determined
-
press drive flange shaft against pinion gear shaft
-
press side gears against housing
-
insert circlip into groove
-
check that circlip does not jam at sides
-
if YES use thinner circlip
Circlips available
Thickness (mm)
Part No.