Golf GTI L4-1781cc 1.8L SOHC (HT) (1985)
-
Reinstall back-up light switch cam sleeve (always use a new self locking nut).
^
Torque nut to 25 Nm. (18 ft. lb.).
-
Lift lug -C- in direction of -arrow-and reinstall gate selector cable to actuating arm/relay lever.
-
Reconnect gear selector cable to gear selector lever (position cable pivot in center of slot on selector lever).
-
Reinstall balance weight -A-.
-
Reinstall back-up light switch housing -D-.
-
Reinstall back-up light switch electrical connector.
-
Road test vehicle.
If Vibration/knocking is still present:
-
Replace selector shaft and housing.
When procedure applies to vehicles within warranty use the following:
Part Identifier:
3445
Labor Operation: 3445510
90 TU