Golf GTI L4-2.0L (ABA) (1997)
3 - Mounting
-
Install release tool 3289 and pull toward rear while holding brake pedal stationary (pedal must not move backward).
-
Mounting -3- retaining tabs (arrows) will be pressed off ball head of push rod -2-.
NOTE: Tool and push rod detail shown with pedal cluster removed.
-
Pull tool 3289 and brake pedal together toward rear.
-
Brake pedal -1- will be pulled off ball-head of push rod -2-
Pedal To Booster Rod Connecting
Connecting Brake Pedal And Push Rod
-
Hold ball-head of push rod and move pedal in direction of arrow until parts lock together with an audible click.
Removal
-
Remove over-center spring for clutch pedal, refer to Transmission and Drivetrain.
Brake Pedal Shaft Retaining Spring Removing
-
Insert Phillips-head screwdriver under tab -A-, press clip in direction of arrow.
NOTE: When installing the clip, make sure that surface -B- is vertical.
-
Unhook spring from brake pedal.
-
Pull out pedal shaft to left-side.
-
Remove brake pedal.
Installation
-
Install in reverse order of removal.