Golf GTI L4-2.0L (ABA) (1997)
-
Quantity used 3
16
Protective sleeve
-
Insert into selector lever housing before attaching selector lever cable, refer to Fig. 4, below.
17
Nut
-
Tighten to: 25 Nm (18 ft lb)
-
With shoulder
18
Selector lever cable
-
To remove selector lever, remove lower protective plate, separate exhaust system in front of catalyst (remove catalyst on 6-Cyl. engines) and
remove front protective plate.
-
Do not bend or kink.
-
Lightly grease cable eye and cable ends before installing.
-
Tighten selector lever cable on cable anchorage/selector lever housing to: 20 Nm (15 ft lb).
19
Seal
-
Bonded to cable anchorage
-
Replace if damaged
-
Check guide tube for tight fit.
-
Check protective sleeve between console and lever/gearshift shaft for proper seating and secure selector lever cable with corrugated locking
element, -item 28-
-
Attach selector lever cable to selector lever, refer to Fig. 3, below.
-
Adjusting, refer to Checking/Adjusting. See: Adjustments
20
Circlip
-
Install after installing selector lever cable, refer to Fig. 4, below.
21
Washer
22
Bolt
-
Tighten to: 6 Nm (53 inch lb)
23
Transmission
24
Lever
-
For selector shaft
25
Console
-
With cable anchorage for selector lever cable
26
Washer
27
Combi-bolt
-
Tighten to: 25 Nm (18 ft lb)
28
Corrugated locking element
-
For selector lever cable
-
Always replace
PROCEDURES
Fig. 1 Selector installing lever housing, removing and installing
-
Remove rear central console.
-
Remove hex nut.
-
Remove lower protective plate.
-
Disconnect Oxygen Sensor connector, separate exhaust system in front of catalyst (remove catalyst on vehicles with 6-Cyl. engine).
-
Remove front protective plate and rear bolts (arrows).