Golf GTI V6-2792cc 2.8L DOHC (AAA) SFI (1998)
Fluid Pump: Service and Repair
Remove/Install
NOTE: Refer to Planetary Gearbox Disassembly/Assembly. See: Service and Repair
COMPONENT NOTES AND INFORMATION
1
Bolt
-
Quantity used, 7
-
Tighten to: 8 Nm (70 inch lb) plus an additional 1/4 turn (90°)
-
The additional turn of 90° may be done in several stages
2
ATF pump with -B2- piston
-
Refer to ATF Pump Disassembly/Assembly
3
O-ring
-
Always replace
-
Place on ATF pump
4
Gasket
-
Always replace
5
Spring cap
-
Quantity used, 6
-
Install 3 spring caps after installing first outer plate
-
Install 3 spring caps before installing last outer plate
6
Spring
-
Quantity used, 3
7
Corrugated spring washer
8
Outer plate -B2-
-
Quantity.
-
Determining thickness of outer plate, refer to Adjusting 2nd and 4th gear brake -B2-. See: Adjustments
9
Inner plate -B2-
-
Quantity.
-
Before installing place new inner plates in ATF for 15 minutes
10
Outer plate -B2-
-
Always install 2 mm thick outer plates
-
Quantity.
11
Outer plate -B2-
-
Fit 3 mm thick outer plate to supporting tube
12
Supporting tube -B2-
-
For the -B2- plate package