Golf GTI V6-2792cc 2.8L DOHC (AAA) SFI (1998)
Selector Shaft: Service and Repair
COMPONENT NOTES AND INFORMATION
NOTE:
^
Multi-function Transmission Range Switch, Transmission Vehicle Speed Sensor and Vehicle Speed Sensor can be tested in the vehicle with On
Board Diagnostic (OBD)
^
The output gear must be removed to disassemble and assemble the parking lock, refer to Removing and installing drive pinion, refer to
Removing/Installing. See: Front Final Drive/Service and Repair
1
Bolt
-
Tighten to: 4 Nm (35 inch lb)
2
Manual selector valve control
-
Adjusting, refer to Remove/Install, See: Valve Body/Service and Repair
-
Removing and installing valve body
3
Selector shaft with selector segment
-
Removing and installing, refer to Fig. 2, below.
4
Spring pin
-
Driving out and in, refer to Fig. 1, below.
5
Engaging lever
-
Install together with selector shaft and detent segment
6
Detent segment
-
Install together with selector shaft and engaging lever
7
Locking washer
8
Bolt
-
Tighten to: 10 Nm ( 7 ft lb)
9
Spring for selector segment
10
Bolt
-
Tighten to: 10 Nm (7 ft lb)
11
O-ring
-
Always replace
-
Only install on shafts with groove for circlip
12
Washer
13
Shaft for detent lever
-
Is secured by circlip and bearing cap of drive pinion
14
Return spring
-
Inserting, refer to Fig. 4, below.