Golf GTI V6-2792cc 2.8L DOHC (AAA) SFI (1998)
Seals and Gaskets: Service and Repair
Differential Side Seal, Manual Transaxle
Transmissions Without Springs Behind Axle Flanges
Identification of Seal
-
Diameter -- a = 40.0 mm (1.575 in.)
-
Height -- b = 10.0 mm (0.394 in.)
Removal
-
Turn steering completely to right (full-lock)
-
Disconnect axle shaft from axle flange
^
Tightening Torque: Axle shaft to axle flange 45 Nm (33 ft lb)
-
Press axle shaft upward as far as possible and support with block of wood, or equivalent, under shaft
CAUTION: Avoid damaging surface finish of axle shaft.
NOTE:
-
Additional Steps for Removal of Left Side Seal.
-
Remove wheel
^
Tightening Torque:
Wheel to wheel hub 110 Nm (31 ft lb)
-
Remove transmission support (A) (where applicable). Disconnect coolant overflow reservoir and lay it aside for access to the support
^
Tightening Torque:
Transmission support to transmission 45 Nm (33 ft lb)
Transmission support to transmission mount 50 Nm (37 ft lb)
-
Position chisel or spacer (A) beneath axle flange and pull flange (right or left) from differential gears by turning bolt (B) (B = a previously
removed housing bolt)
NOTE: If the axle flange shaft falls to come out straight, use two spacers (A), and bolts (B), positioned opposite each other. Tighten both bolts