Golf GTI V6-2792cc 2.8L DOHC (AAA) SFI (1998)
Shifter M/T: Service and Repair
Shift Lever and Shift Lever Boot
020 Transmission
SELECTOR LEVER AND SELECTOR ROD, REMOVING AND INSTALLING
Removing
-
Detach boot from frame.
-
Remove shift knob and boot.
-
Remove frame from center console.
-
Remove nuts securing selector lever housing to center console (arrows).
-
Remove front crossmember (arrow 1) from below exhaust system.
-
Remove heated oxygen sensor, oxygen sensor behind three way catalytic converter, and three way catalytic converter (arrow -2-).
-
Remove front heat shield (arrow -3-).
-
Loosen rear heat shield (arrow -4-) in forward area.
-
Remove boll from clamp for selector rod/selector lever (arrow -1-), and remove front bolt (arrow -2-) from bracket (mounted on steering gear).