Golf III L4-1984cc 2.0L SOHC (1993)
-
Remove self locking nut -7- and back-up light switch cam sleeve -6-.
-
Remove gear shift lever -12-.
-
Remove selector shaft housing attachment bolts -arrows- (tap housing lightly with brass or plastic mallet to loosen).
-
Remove selector shaft with housing from transmission.
-
Enlarge both selector shaft housing attachment holes to 9 mm (approx. 23/64 in.).
-
Reinstall selector shaft with housing using sealant AMV 188 200 03 or equivalent, then adjust according to one of the following conditions.
Vibration/knocking from 1st or 3rd gear:
-
Turn housing right (clockwise as far as possible).
^
Torque bolts to 25 Nm. (18 ft. lb.).
Vibration!knocking from 2nd or 4th gear:
-
Turn housing left (counter clockwise as far as possible).
^
Torque bolts to 25 Nm. (18 ft. lb.).
-
Reinstall gear shift lever.
