GTI L4-1.8L Turbo (AWP) (2003)
-
Release control module connector (arrow -1-) and pull off (arrow -2-).
-
Install brake pedal loading device VAG 1869/2.
-
Connect bleeder bottle hose to left front brake caliper and left rear caliper bleed screw and open bleed screws.
-
Depress brake pedal at least 60 mm (2.36 inch) with brake pedal depressor VAG 1869/2.
-
Close left front and left rear caliper bleed screws.
-
Do not remove brake pedal depressor VAG 1869/2 from brake pedal.
-
Place sufficient lint-free cloths under the control module and hydraulic unit.
Make sure no brake fluid gets onto contacts.
-
Disconnect brake lines -1- from hydraulic unit to brake master cylinder and tie up
-
Disconnect remaining brake lines on hydraulic unit.
-
Seal brake lines and threaded holes with plugs from repair set Part No. 1H0698311 A.
-
Remove bolts -arrows- from hydraulic unit/control module bracket.
-
Remove hydraulic unit with control module.
Removing control module from hydraulic unit.
-
Place the hydraulic unit with control module down on a clean flat surface.
-
Remove E 5 hex socket head bolt -arrows- from hydraulic pump.
CAUTION: The hydraulic pump must not be separated from the hydraulic unit.
-
Separate hydraulic unit with hydraulic pump from control module by lifting carefully off joint -1-.