GTI L4-1.8L Turbo (AWP) (2003)
-
Install guide sleeve T10053/1 onto crankshaft journal.
-
Slide oil seal over guide sleeve onto crankshaft stub.
-
Press in oil seal onto stop using press sleeve T10053 and bolt T10053/2 (M16x 1.5x60).
-
Install crankshaft toothed belt sprocket and hold with counter-hold tool 3415.
-
Tighten center bolt to 90 Nm and turn 90° (1/4 turn) further (turning further can be done in several stages).
Note: Thread and shoulder must be free of oil and grease.
-
Installing toothed belt and adjusting valve timing.
-
Installing ribbed belt and tensioning element.