GTI L4-1.8L Turbo (AWP) (2003)
9
-
Seal
-
Replace if damaged
10
-
Change-over valve
-
To remove valve unclip sideways out of support
-
Before installing remove cap item 1.
-
Checking See Fig. 2
11
-
Vent pipe
-
Black
-
Check securely seated
12
-
Pressure retention valve
-
Checking See Fig. 3
13
-
Vent pipe
-
Black
-
Check securely seated
14
-
Fuel tank
-
Support with engine and transmission jack V.A.G 1383 A when removing
-
Removing and installing
15
-
Clamping washer
16
-
Heat shield
-
For fuel tank
17
-
25 Nm
18
-
Lock nut, 2 Nm
19
-
Fuel tank cover
20
-
Securing strap
-
Note differing length
-
Installation position: Fixing point (holes) point in direction of travel
21
-
Supply pipe
-
Black
-
Check securely seated
-
Press disengaging tabs at connecting piece to pull off fuel filter
-
To fuel supply pipe on fuel rail:
22
-
Fuel filter
-
Installed position: Arrow points in through-flow direction
23
-
Screw type clip
24
-
Vent pipe
-
White
-
Check securely seated
-
Clipped onto side of fuel tank
25
-
Sealing ring
-
Replace if damaged
-
When installing, insert seal "dry" into fuel tank opening
-
only coat to install fuel pump with flange
26
-
Fuel delivery unit
-
Installed position at fuel tank See Fig. 1
-
Removing and installing
-
Removing and installing fuel gauge sender
-
Checking fuel pump
-
Clean strainer if soiled
27
-
Union nut, 75 Nm
-
Remove and install with spanner 3217
28
-
Supply pipe
-
Black
-
Check securely seated
-
Clipped onto side of fuel tank
-
To remove from flange and fuel filter press release button on connecting piece
29
-
Return pipe
-
Blue or with blue marking
-
Clipped onto side of fuel tank
-
Check securely seated
-
To remove from flange press release button on connecting piece
-
From fuel return pipe on fuel rail
30
-
Connector
-
Black, 4-pin
-
For fuel gauge sender (G) and fuel pump (G6)
31
-
10 Nm