GTI L4-1.8L Turbo (AWP) (2003)
^
Do not use any object to tap coil into position.
^
Do not twist coil when installing.
With ignition coil replaced:
-
Check misfire recognition again.
If misfires are recognized:
-
Coil may not be defective, continue to diagnose condition (refer to DTC table in Repair Manual, Group 01 On Board Diagnostic (OBD).
If no misfires are recognized:
-
Clear any stored DTCs.
-
Set Readiness Code, see Readiness code, generating in Repair Manual, Group 01 - On Board Diagnostic (OBD).
Note:
Print outs of DTCs, Freeze frame data (if used) and measuring value blocks 014, 015, 016 and (017 for W8 Models) must be kept on file and a
copy must be included when parts are shipped to the Warranty Test Center.
When procedure applies to vehicles within in the New Vehicle Limited Warranty, use the table.