GTI L4-1.8L Turbo (AWP) (2003)
Engine Control Module: Service and Repair
Kick-Down Point, Learning
Kick-Down Point, Learning
Following replacement of the engine control module or the accelerator pedal, vehicles with automatic transmissions must relearn the kick-down point.
Test conditions
-
Ignition on, engine not running
Test sequence
-
Connect VAG1551 scan tool (VAG1552). Switch ignition on and select engine control module with "Address word" 01 (Connecting scan tool and
selecting engine control module). Refer to "VAG1551 Scan Tool See: Computers and Control Systems/Tools and Equipment
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press keys 0 and 4 for function "Introduction of basic setting" and confirm entry with Q key.
Indicated on display
Basic setting
HELP
Input display group number XXX
-
Press keys 0, 6 and 3 for "Display group number 63" and confirm with Q key.
Indicated on display
System in basic setting 63
->
1
2
3
4
-
Observe display in display zones 3 and 4:
Display: Operate kick down
-
Press accelerator pedal beyond kickdown pressure point to floor.
-
Hold pedal at this point for at least 2 seconds.
-
Observe display in display zones 3 and 4:
Specification: kick Down ADP. runs
then
Specification: kick Down ADP. OK
-
Appears in display zones 3 and 4:
Display: kick Down ERROR
-
End engine basic setting by pressing -> key.
-
Press keys 0 and 6 for function "End output" and confirm entry with Q key.
-
Check accelerator position sender: