GTI L4-1.8L Turbo (AWP) (2003)
Impact Sensor: Service and Repair
Crash Sensor For Driver Side/Passengers Side Rear Side Curtain Protection, Removing and
Installing
Crash Sensor For Driver Side/Passengers Side Rear Side Curtain Protection, Removing And Installing
NOTE:
-
Removal and installation is described for right side of vehicle. same instructions apply for removal and installation for left-hand side.
-
illustration shows chassis version of notchback, removal of crash sensor side rear level airbag is identical for sedan and wagon.
-
Observe notes regarding coding in radio operators manual before disconnecting battery.
-
After connecting battery, vehicle options (radio, clock, electric window regulator) must be checked according to repair manual and/or user manual.
-
"crash sensor for rear side-airbag" sends signal to deploy head-level and side-airbags in certain accident situations.
-
"crash sensor for rear side-airbag on driver /Passengers side" is listed as a replacement part under "control module for side curtain protection".
Removing
-
Switch ignition off.
-
Disconnect battery Ground (GND) strap.
-
Remove wheel housing trim.
CAUTION:
-
Observe safety precautions for working on airbags.
-
Electrostatic charges may result in involuntary deployment of airbag. Therefore, mechanic must be electrostatically discharged before
disconnecting ignition- and Ground (GND) wires. This is done e.g. by briefly grasping chassis or door striker.
-
Disconnect harness connector - 2 -.
-
Remove bolts - 3 - and - 4 -.