GTI L4-1.8L Turbo (AWP) (2003)
-
Remove hex. bolts -1- and -2-.
-
Take out pump.
Installing
-
Fill power steering pump with hydraulic oil.
Fill pump with oil via suction union.
-
Turn hub by hand until oil comes from pressure side.
-
Install power steering pump on bracket and tighten bolts to 25 Nm (18 ft. lbs.).
-
Install suction hose and spring-type clip.
The mark -arrow A- must align with casting seam -arrow-.
The spring-type clip must close off mark -arrow B-.
-
Install new O-rings on banjo bolt.
-
Tighten banjo bolt to 30 Nm (22 ft. lbs.).
Installation is continued in reverse sequence