GTI L4-1.8L Turbo (AWP) (2003)
-
Check 4 ends of Bowden cable sheathings for correct seating in mounts - arrow -.
-
Route Bowden cable - 1 - onto eccentric washer of relay pulleys - 2 - as depicted in illustration.
-
All eccentric washers must be rotate to lowest height, otherwise it is very difficult to install Bowden cable onto last relay pulley.
-
Remove securing plate - 2 - from cable reel - 1 -.
-
Pull both coupling plates with clamping brackets up to lower end of guide rails. When doing this, Bowden cable slide automatically into relay
pulley grooves.
-
Check position of Bowden cable.
Bowden cable must be located correctly in groove at all 4 relay pulleys.
-
Slide coupling plates with clamping brackets back and forth several times on guide rails to check them for proper function.
Vehicles with electrical window regulators
-
Place foam shims contained in repair set between window regulator motor and carrier assembly.
-
Install motor for window regulator.
-
Tighten bolts to 3.5 Nm.
Vehicles with mechanical window regulators
-
Connect transfer element for cable reel - 1 -.
-
Insert new seals - 2 -.