GTI L4-2.0L Turbo (BPY) (2007)
Place a wooden board into the recess of the caliper housing so it is not damaged.
-
Remove protective cap from brake caliper with Trim Removal Wedge 3409.
-
Remove seal with Trim Removal Wedge 3409.
When removing, make sure that surface of cylinder is not damaged.
Brake caliper, installing
-
The surface of the piston and seal must only be cleaned with mineral spirits and then dried.
-
Thinly coat piston and seal with assembly paste G 052 150 A2 before inserting.
-
Install sealing ring in brake caliper.
-
Insert protective cap - A - into assembly tool T10146/1 - 1 -.