GTI L4-2.0L Turbo (BPY) (2007)
/Page-542002.png)
-
Remove collar nut -2- and remove line -1- from connector threads.
-
Remove self-locking nut -3- and remove Battery Interrupt Igniter N253 -4- from connector threads while being careful of connected lines.
-
Disengage harness connector -1- by pulling locking button -2- in direction of arrow.
-
Remove connector -1- and remove Battery Interrupt Igniter N253 -3- from vehicle.
CAUTION: While doing this, observe safety precautions when working on pyrotechnic battery isolation system.
Installing:
Install in reverse order of removal, noting the following:
NOTE:
When installing connector to Battery Interrupt Igniter N253, ensure connector engages audibly.
-
Tighten all threaded connections to specified tightening torque.
-
Connect battery venting hose.
-
Reconnect battery.
CAUTION: Central battery venting hose must not be kinked, closed and/or damaged. Battery acids pose health risks and are explosive.
Carefully route the hose and ensure the battery can vent freely and not into inside of vehicle.
