GTI L4-2.0L Turbo (BPY) (2007)
/Page-931003.png)
-
Saw off two rounded sides of the shear bolt heads so that two flat parallel surfaces result -arrows-.
-
Using locking pliers, remove the shear bolts. Discard the shear bolts.
-
Insert a screwdriver -A- between the protective housing and the retaining plate - arrow
-
Using a screwdriver -A-, pry the protective housing upward and sideways to remove from the retaining plate -arrow-.
-
Disconnect the forward electrical harness connector -1 -
-
Lift up the locking mechanism -2- slightly.
-
Remove the Motronic Engine Control Module (ECM) J623 from the retainer -arrow-.
-
Disconnect the rear electrical harness connector.
Installation
Installation is performed in reverse order of removal. Note the following:
The Motronic Engine Control Module (ECM) J623 must be installed with the protective housing.
