GTI L4-2.0L Turbo (BPY) (2007)
-
Locate black fuel line inside frame channel.
Tip: Final position of insulators should be located inside frame channel where indicated (white arrows).
Installing Rear Insulator
-
Remove foam insulating block at rear of frame channel.
-
Slice insulator Part No. 06A141730A lengthwise on one side to enable installation onto fuel line.
-
Install insulator, as shown.
-
Apply tape or small tie-rap around insulator on line.
Tip:
Do Not apply tape or tie-rap tightly, the insulator must be able to slide on fuel line.
A soap/water mixture may be applied to the line to ease insulator installation.
-
Move insulator into frame channel so that it is positioned half way between rear of channel and oval access hole as illustrated in picture 20- A203.
Installing Front Insulator
-
Install insulator Part No. 06A141730A around the black fuel line through the oval access hole in the frame channel.
-
Move the insulator forward into frame channel and position as illustrated in picture 20-A203.
Tip: Move insulator carefully so that it does not slide off of fuel line inside frame channel.
-
Reinstall the foam insulating block at the rear of the frame channel.
-
Install right side under body cover. Tighten fasteners to 2 Nm (20 in. lbs.). - Verify noise is eliminated.