GTI L4-2.0L Turbo (BPY) (2007)
Brake Booster Vacuum Sensor: Service and Repair
Brake Booster Vacuum Sensor G483, Removing and Installing
Brake Booster Vacuum Sensor G483, removing and installing
Removing
-
Battery, removing and installing.
-
Remove battery carrier.
-
Disconnect harness connector - 1 - from Brake Booster Vacuum Sensor G483 - 2 -.
-
Insert a screwdriver between stop and one end of securing ring into groove of sealing ring.
-
Now press securing ring - 1 - as far out of groove until Brake Booster Vacuum Sensor G483 - 2 - can be pulled out of brake booster.
Installing
-
Installation is in reverse order of removal.