GTI L4-2.0L Turbo (BPY) (2007)
Brake Light Switch: Service and Repair
Brake Light Switch F Through CW 45/05, Removing and Installing
Brake Light Switch F through CW 45/05, removing and installing
Includes Brake Pedal Switch F47
On vehicles from CW 45/05, brake light switch is located on brake master cylinder.
Brake light switch, old version
Note:
^
After removing the old brake light switch (see illustration N46-0359) it should be replaced with a new one (see illustration N46-10145).
^
Distinguishing characteristics, see.
Removing
-
Remove trim on drivers side.
-
If necessary, remove footwell vents.
^
Disconnect connector from brake light switch.
The brake light switch must only be removed when plunger is pressed (brake pedal not operated), otherwise retainer on brake light switch will be
damaged.
-
Remove brake light switch by turning 45° to left.
Installing, adjusting and locking
Because old brake light switch is no longer used, there is no description here.
New brake light switch installing, adjusting and locking.
Brake light switch, old version
Note:
^
Only use new brake light switches.
^
The most noticeable difference is the new brake light switch has a clear rounded end on the plunger head - A -.
Removing
-
Remove trim on drivers side.