GTI L4-2.0L Turbo (BPY) (2007)
Installing spring
-
Insert spring so that leg - A - contacts upper part of pin - arrow -.
-
Then pull leg - B - far enough downward so that it rests on underside of pin - arrow -.
Shift Lever and Shift Housing (From 10.06), Servicing
Shift lever and shift housing (from 10.06), servicing 02Q, 6 Speed M/T
Note:
^
Lubricate bearing areas and slide surfaces with grease G 000 450 02.
^
Selector mechanism, disassembling and assembling
1 -
Base plate
^
Bend open tabs to remove
^
Always replace
2 -
Gasket
^
Always replace
3 -
Shift lever
4 -
Damping washer
^
Slide out of shift lever as far as stop - arrow