GTI L4-2.0L Turbo (CBFA) (2008)
Rear Door Panel: Service and Repair
Rear Door Trim
Rear Door Trim
NOTE: Removal and installation is described for the right rear door trim panel. Removal and installation of the left rear door trim panel is performed in
the same manner.
Removing
-
Switch off ignition.
Only vehicles with manual window regulators
-
Remove window crank
-
Pry upper section of grip shell - 1 - out of pull handle in door trim using wedge 3409 .
-
Remove bolts - 2 - and - 3 - (1.5 Nm).
-
Remove bolt - 4 - (2 Nm).
-
Disengage door trim from mounts in lower area using disassembly pliers 3392 .
-
Disengage door trim from mounts on the sides using disassembly pliers 3392 .
-
Pull door trim vertically upward out of window shaft.
-
Depending on vehicle equipment, disconnect wiring harnesses from door trim.
-
Detach release cable - 5 - from inside door release mechanism - 6 -.