GTI L4-2.0L Turbo (CBFA) (2008)
Sunroof / Moonroof Windguard: Service and Repair
Wind Deflector
Removing
-
Open sunroof glass panel completely.
-
Press wind deflector with height stop out of front roof cut-out and tilt wind deflector open vertically.
-
Insert special tool hook for front end 3370 between roof edge and wind deflector bearing - arrow -.
-
Pull wind deflector bearing out of side locking mechanism of left and right guide rails using special tool hook for front end 3370 in - direction of
arrow -.
-
Remove wind deflector upward from guide rail.
Installing
-
Insert wind deflector into guide rail and slide wind deflector with height stop under front roof opening at left and right sides.
-
Using light pressure, press wind deflector bearing into guide rails.
NOTE: Wind deflector bearing must engage in guide rails audibly.
Wind Deflector, from 08.05, Adjusting
On vehicles from 08.2005, the wind deflector can be adjusted.
-
Insert special tool Special Hook 3370 between roof edge and wind deflector bearing - 2 -.
-
Pull wind deflector bearing - 2 - out of side locking mechanism of left and right guide rails using special tool Special Hook 3370 in - direction of
arrow a -.
-
Slide wind deflector - 1 - parallel into guide rails - arrow b - until dimension - c - is adjusted between 0.3 mm and 1.3 mm.
-
Press wind deflector bearing - 2 - into guide rails.
NOTE: Wind deflector bearing must engage in guide rails audibly.