GTI L4-2.0L Turbo (CBFA) (2008)
Sound Proofing / Insulation: Service and Repair
Roof Insulation and Reinforcement
Removing
CAUTION: Observe safety precautions for working on airbags.
-
If present, open sunroof.
-
Disconnect vehicle battery.
-
Remove sun visors.
-
Remove roof grab handle.
-
Remove lights and switch in molded headliner.
-
Remove roof end strip
-
Remove upper A-pillar trim
-
Remove upper B-pillar trim. Belt anchors or front belt anchor rails do not have to be removed.
2-door only
-
Remove seat bench .
-
Remove backrest.
-
Remove side trim.
4-door only
-
Remove seat bench -Rear Seat Bench .
-
Remove 4-door side upholstery:
-
with rear side airbags.
-
without rear side airbags.
All vehicles
-
Remove luggage compartment cover side compartment
-
Remove trim on C-pillars.
-
Remove molded headliner.
NOTE: A different vehicle is shown as an example in the following illustrations. Removal and installation of insulation/reinforcements is same in
Rabbit/GTI.
-
Cut roof insulation/reinforcements - 1 - in direction of travel in strips approx. 6 cm wide - 2 - using a carpet knife.
-
Pull off strips - 2 - from roof.
-
Cut back adhesive residue - 3 - using electric cutter V.A.G 1561 A and cutting blade V.A.G 1561/20 - 4 -.
NOTE: If paint structure was damaged while removing roof insulation/reinforcements, paint damage must be repaired in accordance with
specifications in Repair Manual Paint .