GTI L4-2.0L Turbo (CBFA) (2008)
-
This way, the seal is pressed to the side - arrow a - so the application roller 3356 comes into direct contact with the seal contact surface.
The force - arrow b - from the application roller can only reach the adhesive surface - 2 - if the procedure described above is used.
-
If the seal has become too long, cut it back to the correct length and press the area with the joint on well.
-
If small areas of the seal - 3 - loosen again, press them back on with the application roller 3356 .
NOTE: To ensure the outer door seal does not loosen or slide again, do not close the door for 2 hours.