GTI L4-2.0L Turbo (CBFA) (2008)
-
Release contact lock using assembly tool with correct fit - A - and then pull wire with single wire seal toward rear - arrow - out of contact housing.
-
Cut off the old contact with single wire seal from the vehicle-specific wiring harness.
-
Slide repair wire with new contact into corresponding chamber of contact housing until it engages.
-
Put single wire seal - A - on to free end of repair wire.
NOTE: When doing this, small diameter of single wire seal must point toward contact housing.
-
Slide single wire seal - A - on to repair wire up to the contact housing.